| Type: |
Amateur HF/VHF SDR transceiver |
| Frequency Range: |
TX: 10-160 m + WARC / 6 m
RX: 0.01-55 MHz |
| Mode: |
Allmode, depending on software |
| Tuning steps: |
Depending on software |
| RF Power output: |
10-20W |
| Channels/memory management: |
Depending on software |
| Repeater shift/offset: |
Depending on software |
| Voltage: |
13.8 VDC |
| Current Drain: |
RX: ?? A
TX: Max ?? A |
| Aerial Input: |
50 ohms, 3x BNC (for RX/TX) |
| Dimensions (W*H*D): |
?? x ?? x ?? mm |
| Weight: |
? Kg |
| Manufactured: |
India, 201x-201x |
| Other: |
Supports seven fully independent receivers (software dependent)
Each receiver can display 48/96/192/384/1152 KHz of spectrum.
Full duplex, any split over the entire range. Full QSK.
Transverter output. Ethernet connection
Differences between the ANAN-10 & the ANAN-10E
1. The ANAN-10E uses a 14 bit ADC while the ANAN-10 uses a 16 bit ADC
2. The ANAN-10E uses an EP3C25 FPGA while the ANAN-10 uses a larger EP3C40
3. The ANAN-10E supports 2 receivers while the ANAN-10 supports 7 receiversst high end legacy radios.
|
| Related Documents: |
|
